When considering introduction point of a service's descriptor, do not remove
an intro point that has an established or pending circuit.
Fixes#31652
Signed-off-by: David Goulet <dgoulet@torproject.org>
When encoding introduction points, we were not checking if that intro points
had an established circuit.
When botting up, the service will pick, by default, 3 + 2 intro points and the
first 3 that establish, we use them and upload the descriptor.
However, the intro point is removed from the service descriptor list only when
the circuit has opened and we see that we have already enough intro points, it
is then removed.
But it is possible that the service establishes 3 intro points successfully
before the other(s) have even opened yet.
This lead to the service encoding extra intro points in the descriptor even
though the circuit is not opened or might never establish (#31561).
Fixes#31548
Signed-off-by: David Goulet <dgoulet@torproject.org>
Our minimum version is now 0.2.9.5-alpha. Series 0.3.0, 0.3.1,
0.3.2, 0.3.3, and 0.3.4 are now rejected.
Also, extract this version-checking code into a new function, so we
can test it.
Closes ticket 31549.
Also reject 0.3.5.0 through 0.3.5.6-rc as unstable.
When pkg-config is not installed, or a library that depends on
pkg-config is not found, tell the user what to do to fix the
problem.
Fixes bug 31922; bugfix on 0.3.1.1-alpha.
The documentation for this function says that the smartlist can
contain NULLs, but the code only handled NULLs if they were at the
start of the list.
We didn't notice this for a long time, because when Tor is run
normally, the sequence of msg_id_t is densely packed, and so this
list (mapping msg_id_t to channel_id_t) contains no NULL elements.
We could only run into this bug:
* when Tor was running in embedded mode, and starting more than once.
* when Tor ran first with more pubsub messages enabled, and then
later with fewer.
* When the second run (the one with fewer enabled pubsub messages)
had at least some messages enabled, and those messages were not
the ones with numerically highest msg_id_t values.
Fixes bug 31898; bugfix on 47de9c7b0a
in 0.4.1.1-alpha.
There is a bad design choice in two of our configuration types,
where the empty string encodes a value that is not the same as the
default value. This design choice, plus an implementation mistake,
meant that config_dup() did not preserve the value of routerset_t,
and thereby caused bug #31495.
This comment-only patch documents the two types with the problem,
and suggests that implementors try to avoid it in the future.
Closes ticket 31907.
