Commit Graph

603 Commits

Author SHA1 Message Date
Nick Mathewson
6dd7f85bc7 Try to make most routerstatus_t interfaces const 2010-10-01 18:14:27 -04:00
Nick Mathewson
d84d20cbb2 Try to make most routerinfo_t interfaces const 2010-10-01 18:14:27 -04:00
Roger Dingledine
3cbe463e96 Merge branch 'bug1772' into maint-0.2.2 2010-09-29 23:52:18 -04:00
Roger Dingledine
f2aa8f08cb fix two casts 2010-09-29 23:51:25 -04:00
Mike Perry
c8f731fabb Comment network liveness and change detection behavior. 2010-09-29 19:35:40 -07:00
Roger Dingledine
7f10707c42 refactor and recomment; no actual changes 2010-09-29 18:01:22 -04:00
Roger Dingledine
474e4d2722 Merge commit 'mikeperry/bug1740' into maint-0.2.2 2010-09-29 17:05:38 -04:00
Mike Perry
4324bb1b21 Cap the circuit build timeout to the max time we've seen.
Also, cap the measurement timeout to 2X the max we've seen.
2010-09-29 11:49:43 -07:00
Mike Perry
11910cf5b3 Do away with the complexity of the network liveness detection.
We really should ignore any timeouts that have *no* network activity for their
entire measured lifetime, now that we have the 95th percentile measurement
changes. Usually this is up to a minute, even on fast connections.
2010-09-29 11:49:43 -07:00
Mike Perry
0744a175af Fix state checks on liveness handling.
If we really want all this complexity for these stages here, we need to handle
it better for people with large timeouts. It should probably go away, though.
2010-09-29 11:49:43 -07:00
Mike Perry
9a77743b7b Fix non-live condition checks.
Rechecking the timeout condition was foolish, because it is checked on the
same codepath. It was also wrong, because we didn't round.

Also, the liveness check itself should be <, and not <=, because we only have
1 second resolution.
2010-09-29 11:49:31 -07:00
Mike Perry
5aa4564ab9 Only count timeout data for 3 hop circuits.
Use 4/3 of this timeout value for 4 hop circuits, and use half of it for
canabalized circuits.
2010-09-29 11:41:27 -07:00
Roger Dingledine
512433346f improve code comments, based on comments from nick 2010-09-28 23:27:00 -04:00
Roger Dingledine
9997676802 handle ugly edge case in retrying entrynodes
Specifically, a circ attempt that we'd launched while the network was
down could timeout after we've marked our entrynodes up, marking them
back down again. The fix is to annotate as bad the OR conns that were
around before we did the retry, so if a circuit that's attached to them
times out we don't do anything about it.
2010-09-28 22:32:38 -04:00
Roger Dingledine
7de1caa33f Actually notice when our last entrynode goes down
Otherwise we'd never set have_minimum_dir_info to false, so the
"optimistic retry" would never trigger.
2010-09-28 21:59:31 -04:00
Roger Dingledine
bb22360bad optimistically retry EntryNodes on socks request
We used to mark all our known bridges up when they're all down and we
get a new socks request. Now do that when we've set EntryNodes too.
2010-09-28 19:10:23 -04:00
Roger Dingledine
8bac188572 remove a redundant assert 2010-09-28 19:10:22 -04:00
Roger Dingledine
127f37ad29 refactor; no actual changes 2010-09-28 19:10:22 -04:00
Roger Dingledine
09a715bb72 Merge branch 'maint-0.2.1' into maint-0.2.2 2010-09-28 18:37:55 -04:00
Roger Dingledine
339993b409 actually retry bridges when your network goes away 2010-09-28 18:36:15 -04:00
Nick Mathewson
c9cb4f0a0e Rename has_completed_circuit to can_complete_circuit
Also redocument it.  Related to #1362.
2010-09-22 01:52:57 -04:00
Roger Dingledine
47b23bd03e A start at a patch for bug 1943 (alignment issues) 2010-09-20 18:40:32 -04:00
Nick Mathewson
01c6b01137 I hear we are close to a release. Clean up the whitespace. 2010-09-16 15:44:14 -04:00
Nick Mathewson
f89323afda Fix behavior of adding a cell to a blocked queue.
We frequently add cells to stream-blocked queues for valid reasons
that don't mean we need to block streams.  The most obvious reason
is if the cell arrives over a circuit rather than from an edge: we
don't block circuits, no matter how full queues get.  The next most
obvious reason is that we allow CONNECTED cells from a newly created
stream to get delivered just fine.

This patch changes the behavior so that we only iterate over the
streams on a circuit when the cell in question came from a stream,
and we only block the stream that generated the cell, so that other
streams can still get their CONNECTEDs in.
2010-09-02 15:26:17 -04:00
Nick Mathewson
b51f1a64e4 Make Sebastian's bug1831 branch build with --enable-gcc-warnings 2010-08-15 23:46:09 -04:00
Sebastian Hahn
561ca9b987 Fix misplaced labels 2010-08-16 00:46:44 +02:00
Sebastian Hahn
4c49d3c27e Refactor circuit_build_times_parse_state
Remove the msg parameter to pass an error message out. This
wasn't needed and made it harder to detect a memory leak.
2010-08-16 00:45:32 +02:00
Sebastian Hahn
70f0ba1495 Fix a memory leak in circuit_build_times_parse_state
Thanks weasel for noticing.
2010-08-16 00:33:29 +02:00
Sebastian Hahn
05072723cb Create routerparse.h 2010-07-27 10:00:46 +02:00
Sebastian Hahn
df9d42cef5 Create rephist.h 2010-07-27 10:00:46 +02:00
Sebastian Hahn
b0cd4551ab Create relay.h 2010-07-27 10:00:45 +02:00
Sebastian Hahn
7bd8dee463 Create policies.h 2010-07-27 10:00:45 +02:00
Sebastian Hahn
f6852fe031 Create onion.h 2010-07-27 10:00:45 +02:00
Sebastian Hahn
69fcbbaa89 Create networkstatus.h 2010-07-27 07:58:16 +02:00
Sebastian Hahn
0f1548ab18 Create main.h 2010-07-27 07:58:16 +02:00
Sebastian Hahn
bec1c838ca Create directory.h 2010-07-27 07:58:15 +02:00
Sebastian Hahn
0bfa34e1f6 Create control.h 2010-07-27 07:58:15 +02:00
Sebastian Hahn
0d33120c26 Create connection_or.h 2010-07-27 07:58:15 +02:00
Sebastian Hahn
78b6a4650b Create connection_edge.h 2010-07-27 07:58:14 +02:00
Sebastian Hahn
2a74101f7a Create connection.h 2010-07-27 07:58:14 +02:00
Sebastian Hahn
c4f8f1316e Create config.h 2010-07-27 07:58:14 +02:00
Sebastian Hahn
01c7b60a80 Create circuituse.h 2010-07-27 07:58:14 +02:00
Sebastian Hahn
174a88dd79 Create circuitlist.h 2010-07-27 07:58:13 +02:00
Sebastian Hahn
21155204c6 Create circuitbuild.h 2010-07-27 07:58:13 +02:00
Sebastian Hahn
cbee969f40 Create routerlist.h 2010-07-27 07:56:25 +02:00
Sebastian Hahn
c53b6cc831 Create router.h 2010-07-27 07:56:25 +02:00
Roger Dingledine
1d6656fcb3 mike needs DEFAULT_ROUTE_LEN in other files 2010-07-21 09:30:26 -04:00
Roger Dingledine
66d5ce266e naked constants are bad 2010-07-20 08:07:44 -04:00
Nick Mathewson
0b4b51314f Make the controller act more usefully when GETINFO fails
Right now it says "552 internal error" because there's no way for
getinfo_helper_*() countries to specify an error message.  This
patch changes the getinfo_helper_*() interface, and makes most of the
getinfo helpers give useful error messages in response to failures.

This should prevent recurrences of bug 1699, where a missing GeoIPFile
line in the torrc made GETINFO ip-to-county/* fail in a "not obvious
how to fix" way.
2010-07-18 17:05:58 +02:00
Mike Perry
a9edb0b4f6 More gracefully handle corrupt state files.
Save a backup if we get odd circuitbuildtimes and other state info.

In the case of circuit build times, we no longer assert, and reset our state.
2010-07-06 12:11:22 -07:00