There are still quite a few 0.2.3.2x relays running for x<5, and while I
agree they should upgrade, I don't think cutting them out of the network
is a net win on either side.
This change prevents LD_BUG warnings and bootstrap failure messages
when we try to do directory fetches when starting with
DisableNetwork == 1, a consensus present, but no descriptors (or
insufficient descriptors) yet.
Fixes bug 11200 and bug 10405. It's a bugfix on 0.2.3.9-alpha.
Thanks to mcs for walking me through the repro instructions!
This is meant to be a better bug 9229 fix -- or at least, one more
in tune with the intent of the original code, which calls
router_retry_directory_downloads() only on the first bridge descriptor.
This prevents long stalls when we're starting with a state file but
with no bridge descriptors. Fixes bug 9229. I believe this bug has
been present since 0.2.0.3-alpha.
By default, after you've made a connection to port XYZ, we assume
you might still want to have an exit ready to connect to XYZ for one
hour. This patch lets you lower that interval.
Implements ticket 91
We have ignored any ports listed here since 80365b989 (0.0.7rc1),
but we didn't warn the user that we were ignoring them. This patch
adds a warning if you put explicit ports in any of the options
{Socks,Dir}Policy or AuthDir{Reject,Invalid,BadDir,BadExit}. It
also adjusts the manpage to say that ports are ignored.
Fixes ticket 11108.
See 1d2179bc90 in master for details.
"""
Fall back to registered country if necessary.
When extracting geoip and geoip6 files from MaxMind's GeoLite2 Country
database, we only look at country->iso_code which is the two-character ISO
3166-1 country code of the country where MaxMind believes the end user is
located.
But if MaxMind thinks a range belongs to anonymous proxies, they don't put
anything there. Hence, we omit those ranges and resolve them all to '??'.
That's not what we want.
What we should do is first try country->iso_code, and if there's no such
key, try registered_country->iso_code which is the country in which the
ISP has registered the IP address.
In short: let's fill all A1 entries with what ARIN et. al think.
"""
It's possible for two threads to hit assertion failures at the same
time. If that happens, let's keep them from stomping on the same
cb_buf field.
Fixes bug 11048; bugfix on 0.2.5.2-alpha. Reported by "cypherpunks".
This should make more platforms (in particular, ones with compilers
where -fomit-frame-pointer is on by default but table generation
isn't) support backtrace generation. Thanks to cypherpunks for this
one.
Fixes bug 11047; bugfix on 0.2.5.2-alpha.
Back in 5e762e6a5c, non-exit servers
stopped launching DNS requests for users. So there's no need for them
to see if their DNS answers are hijacked.
Patch from Matt Pagan. I think this is a 965 fix.
For a client using a SocksPort connection and IPv6, the connect reply
from tor daemon did not handle AF_INET6 thus sending back the wrong
payload to the client.
A changes file is provided and this fixes#10987
Signed-off-by: David Goulet <dgoulet@ev0ke.net>
On busy servers, this function takes up something like 3-7% in
different profiles, and gets invoked every time we need to participate
as the midpoint in a hidden service.
So maybe walking through a linked list of all the circuits here wasn't
a good idea.
We log only one message, containing a complete list of what's
wrong. We log the complete list whenever any of the possible things
that could have gotten wrong gets worse.
Fix for #9870. Bugfix on 10480dff01, which we merged in
0.2.5.1-alpha.
If you had a resolv.conf file with a nameserver line containing no
nameserver IP, we would crash. That's not terrible, but it's not
desirable.
Fixes bug 8788; bugfix on 0.1.1.23. Libevent already has this fix.
These options were added back in 0.1.2.5-alpha, but no longer make any
sense now that all directories support tunneled connections and
BEGIN_DIR cells. These options were on by default; now they are
always-on.
This is a fix for 10849, where TunnelDirConns 0 would break hidden
services -- and that bug arrived, I think, in 0.2.0.10-alpha.
This is a bugfix on 0.2.2.26-beta, because 6b83b3b made directory
authorities remove themselves from the list of directory authorities to
upload to, but didn't suppress the warning in case they're the only
directory authority in the network.
(There is no longer meaningfully any such thing as a HS authority,
since we stopped uploading or downloading v0 hs descriptors in
0.2.2.1-alpha.)
Implements #10881, and part of #10841.
Apparently fedora currently has ECDH but not P224. This isn't a huge
deal, since we no longer use OpenSSL's P224 ever (see #9780 and
72c1e5acfe). But we shouldn't have segfaulting benchmarks really.
Fixes bug 10835; bugfix on 0.2.4.8-alpha.
This time, we use a pthread_attr to make sure that if pthread_create
succeeds, the thread is successfully detached.
This probably isn't the big thing going on with 4345, since it'd be
a bit weird for pthread_detach to be failing. But it's worth
getting it right.
Right now this accounts for about 1% of circuits over all, but if you
pick a guard that's running 0.2.3, it will be about 6% of the circuits
running through that guard.
Making sure that every circuit has at least one ntor link means that
we're getting plausibly good forward secrecy on every circuit.
This implements ticket 9777,
It's possible to set your ExitNodes to contains only exits that don't
have the Exit flag. If you do that, we'll decide that 0 of your exits
are working. Instead, in that case we should look at nodes which have
(or which might have) exit policies that don't reject everything.
Fix for bug 10543; bugfix on 0.2.4.10-alpha.
If you want a slow shutdown, send SIGNAL SHUTDOWN.
(Why not just have the default be SIGNAL QUIT? Because this case
should only happen when an owning controller has crashed, and a
crashed controller won't be able to give the user any "tor is
shutting down" feedback, and so the user gets confused for a while.
See bug 10449 for more info)
The remaining vestige is that we continue to publish the V2dir flag,
and that, for the controller, we continue to emit v2 directory
formats when requested.
Previously, we would sometimes decide in directory_get_from_hs_dir()
to connect to an excluded node, and then later in
directory_initiate_command_routerstatus_rend() notice that it was
excluded and strictnodes was set, and catch it as a stopgap.
Additionally, this patch preferentially tries to fetch from
non-excluded nodes even when StrictNodes is off.
Fix for bug #10722. Bugfix on 0.2.0.10-alpha (the v2 hidserv directory
system was introduced in e136f00ca). Reported by "mr-4".
If we don't, we can wind up with a wedged cpuworker, and write to it
for ages and ages.
Found by skruffy. This was a bug in 2dda97e8fd, a.k.a. svn
revision 402. It's been there since we have been using cpuworkers.
When I introduced the unusable_for_new_circuits flag in
62fb209d83, I had a spurious ! in the
circuit_stream_is_being_handled loop. This made us decide that
non-unusable circuits (that is, usable ones) were the ones to avoid,
and caused it to launch a bunch of extra circuits.
Fixes bug 10456; bugfix on 0.2.4.12-alpha.
When we wrote the directory request statistics code in August 2009, we
thought that these statistics were only relevant for bridges, and that
bridges should not report them. That's why we added a switch to discard
relevant observations made by bridges. This code was first released in
0.2.2.1-alpha.
In May 2012 we learned that we didn't fully disable directory request
statistics on bridges. Bridges did report directory request statistics,
but these statistics contained empty dirreq-v3-ips and dirreq-v3-reqs
lines. But the remaining dirreq-* lines have always been non-empty. (We
didn't notice for almost three years, because directory-request statistics
were disabled by default until 0.2.3.1-alpha, and all statistics have been
removed from bridge descriptors before publishing them on the metrics
website.)
Proposal 201, created in May 2012, suggests to add a new line called
bridge-v3-reqs that is similar to dirreq-v3-reqs, but that is published
only by bridges. This proposal is still open as of December 2013.
Since October 2012 we're using dirreq-v3-resp (not -reqs) lines in
combination with bridge-ips lines to estimate bridge user numbers; see
task 8462. This estimation method has superseded the older approach that
was only based on bridge-ips lines in November 2013. Using dirreq-v3-resp
and bridge-ips lines is a workaround. The cleaner approach would be to
use dirreq-v3-reqs instead.
This commit makes bridges report the same directory request statistics as
relays, including dirreq-v3-ips and dirreq-v3-reqs lines. It makes
proposal 201 obsolete.
In 0.2.3.8-alpha we attempted to "completely disable stats if we aren't
running as a relay", but instead disabled them only if we aren't running
as a server.
This commit leaves DirReqStatistics enabled on both relays and bridges,
and disables (Cell,Entry,ExitPort)Statistics on bridges.
This fixes bug 10402, where the rdrand engine would use the rdrand
instruction, not as an additional entropy source, but as a replacement
for the entire userspace PRNG. That's obviously stupid: even if you
don't think that RDRAND is a likely security risk, the right response
to an alleged new alleged entropy source is never to throw away all
previously used entropy sources.
Thanks to coderman and rl1987 for diagnosing and tracking this down.
The 'body' field of a microdesc_t holds a strdup()'d value if the
microdesc's saved_location field is SAVED_IN_JOURNAL or
SAVED_NOWHERE, and holds a pointer to the middle of an mmap if the
microdesc is SAVED_IN_CACHE. But we weren't setting that field
until a while after we parsed the microdescriptor, which left an
interval where microdesc_free() would try to free() the middle of
the mmap().
This patch also includes a regression test.
This is a fix for #10409; bugfix on 0.2.2.6-alpha.
The old behavior was that NULL matched only bridges without known
identities; the correct behavior is that NULL should match all
bridges (assuming that their addr:port matches).
We were checking whether a 8-bit length field had overflowed a
503-byte buffer. Unless somebody has found a way to store "504" in a
single byte, it seems unlikely.
Fix for 10313 and 9980. Based on a pach by Jared L Wong. First found
by David Fifield with STACK.
This flag prevents the creation of a console window popup on Windows. We
need it for pluggable transport executables--otherwise you get blank
console windows when you launch the 3.x browser bundle with transports
enabled.
http://msdn.microsoft.com/en-us/library/ms684863.aspx#CREATE_NO_WINDOW
The browser bundles that used Vidalia used to set this flag when
launching tor itself; it was apparently inherited by the pluggable
transports launched by tor. In the 3.x bundles, tor is launched by some
JavaScript code, which doesn't have the ability to set CREATE_NO_WINDOW.
tor itself is now being compiled with the -mwindows option, so that it
is a GUI application, not a console application, and doesn't show a
console window in any case. This workaround doesn't work for pluggable
transports, because they need to be able to write control messages to
stdout.
https://trac.torproject.org/projects/tor/ticket/9444#comment:30
On platforms with the backtrace/backtrace_symbols_fd interface, Tor
can now dump stack traces on assertion failure. By default, I log
them to DataDir/stack_dump and to stderr.
Conflicts:
src/or/or.h
src/or/relay.c
Conflicts were simple to resolve. More fixes were needed for
compilation, including: reinstating the tv_to_msec function, and renaming
*_conn_cells to *_chan_cells.
In proposal 157, we added a cross-certification element for
directory authority certificates. We implemented it in
0.2.1.9-alpha. All Tor directory authorities now generate it.
Here, as planned, make it required, so that we can finally close
proposal 157.
The biggest change in the code is in the unit test data, where some
old hardcoded certs that we made long ago have become no longer
valid and now need to be replaced.
Previously, when we ran low on memory, we'd close whichever circuits
had the most queued cells. Now, we close those that have the
*oldest* queued cells, on the theory that those are most responsible
for us running low on memory, and that those are the least likely to
actually drain on their own if we wait a little longer.
Based on analysis from a forthcoming paper by Jansen, Tschorsch,
Johnson, and Scheuermann. Fixes bug 9093.
As a bridge authority, before we create our networkstatus document, we
should compute the thresholds needed for the various status flags
assigned to each bridge based on the status of all other bridges. We
then add these thresholds to the networkstatus document for easy access.
Fixes for #1117 and #9859.
Also fix a bug where if the guard we choose first doesn't answer, we
would try the second guard, but once we connected to the second guard
we would abandon it and retry the first one, slowing down bootstrapping.
The fix in both cases is to treat all our initially chosen guards as
acceptable to use.
Fixes bug 9946.
